86.5 MW GE (General Electric) 7E.03 Natural Gas Generator Package

Description:

The package comprises the following major components along with all GE scope of supply and auxiliaries:

• Frame 7EA Gas Turbine model PG7001EA (7E.03)
• Dry Low NOx (for DLN 1.0 Combustion System*)
• Natural gas single fuel supply
• Design Site Output/Heat Rate 84.6MW at 1916 ft and 32°F; 91MW at 0 ft and 32°F
• Includes GE PIP package (minus Stg 3 Aero), 2055°F firing temp
• Inlet/Exhaust: Pressure drop: 3.5/5.5 inches of H2O
• Hours: factory test fire only, i.e. New
• Control System: MKVIe Speedtronic TMR
• Generator: GE/Andritz
• Frame: BDAX (Brushless)
• Excitation: GE EX2100
• Frequency/Power Factor: 60 Hz/0.85 pf
• Rated Output: 101.8 MVA
• Cooling: Air-cooled
• Designed for the Canadian Market
• Stored in accordance with GE’s storage/preservation requirements
• Unit has not been rotated  – Not required on 3 bearing units
• Borescope on GTG and quarterly electrical insulation resistance check on the generator

Other Auxiliary Equipment Available Upon Request
(not included in asking price – please call us to inquire):

• Air Cooled Glycol Heat Exchangers c/w VFD’s, Filters, Glycol Pumps, GSU Transformer,
• Glycol Expansion Vessel, 52G synchronizing breaker compartment included @ 13.8KV incl. all protection relays etc. – Terminal Voltage: 13.8Kv (2 pole, 3-phase, Wye conn.)
• Heat Recovery Steam Generator (HRSG – Not Complete)

*Combustion system (for GTG) not included or installed – Combustor Components from refurbished parts are available upon request at additional cost.

Below is the list of missing combustion components:

• Primary Fuel Nozzles
• Secondary Fuel Nozzles
• Flow Sleeves
• Liners
• Cross Fire Tubes
• Transition Pieces and TP Seals
• All gaskets, nuts, bolts, screws, pins to install the above